Somta
Somta Center Drill ( Inch )
When one end dulls, turn the countersink around for a fresh cutting edge. The&nb..
Somta Center Drill ( Metric )
When one end dulls, turn the countersink around for a fresh cutting edge. The&nb..
Somta Countersink Drill 3 Flute (60 Degree & 90 Degree)
To remove the need for a starter hole, the drill point is incorporated into the count..
Somta Double Ended Sheet Metal Drill Bit 135° Degree
When one end becomes worn, reverse the bit to use the other end. These bits have..
Somta Double Equal Angle Cutter 1" Bore
2.3/4" x 1/2" x 45 degree2.3/4" x 1/2" x 90 degree4 x 3/4" x 90 degree..
Somta H.S.S. Spiral Flute Tap ( Inch )
The spiral flute design pulls chips back toward the tap, so chips won't acc..
Somta H.S.S. Spiral Flute Tap ( Metric.)
The spiral flute design pulls chips back toward the tap, so chips won't acc..
Somta Half Shank Drill Bit Inch
The shank has a smaller diameter than the tip, allowing you to drill large holes with..
Somta Half Shank Drill Bit Metric
The shank has a smaller diameter than the tip, allowing you to drill large holes with..
Somta Hand Reamer Spiral Flute ( Inch )
Spiral-flute reamers have a left-hand spiral and a right-hand cut. They push chi..
Somta Hand Reamer Spiral Flute (Metric)
Spiral-flute reamers have a left-hand spiral and a right-hand cut. They push chi..
Somta Hand Taper Pin Reamer
No. 111/64”No. 2 3/16”No. 3 7/32”No. 4 1/4”No. 59/32”5/16”No. 611/32”3/8”No. 713/327/..
Somta HSS End Mill 2 Flute Ball (Metric)
Two flute, high speed steel (HSS) end mills are designed for general purpose milling operations on m..
Somta HSS End Mill 4 Flute (Metric)
Four flute, high speed steel (HSS) end mills are designed for center cutting milling operations on m..